TIS 2000 SOFTWARE HOW TO
TIS 2000 SOFTWARE INSTALL
TIS 2000 SOFTWARE SOFTWARE

Note: If the TIS2000 software was previous installed and removed from the PC, a message may appear asking to reuse old settings. The TIS 2000 Installation Welcome window appears automatically.

TIS 2000 SOFTWARE INSTALL

To install the SPS software, follow these steps:ġ Insert the Application CD into the PC’s CD drive. Install the SPS Application CD software, which includes installing the USB security key (security device). 5 Continue with the steps in the next section, “Install the SPS Software” Windows then installs the protocol automatically. This displays the Connection Properties dialog box (see Figure 1.4 on page 3).Ģ In the Connection Properties dialog box, see if TCP/IP is already listed under “This connection uses the following items.” If not, click the Install button to display the Select Network Component Type dialog box.ģ Click Protocol and then click the Add button to display the Select Network Protocol dialog boxĤ Under Manufacturer, select Microsoft and under Network Protocol, select Internet Protocol (TCP/IP). With the Internet Connections window displayed, right click Local Area Connection and then select Properties (see Figure 1.3). For Windows 2000, right click the My Network Places icon on the Windows desktop.This displays the Connection Properties dialog box (see Figure 1.4 on page 3). With the Control Panel window displayed, select Network and Internet Connections (see Figure 1.1 and Figure 1.2). For Windows XP, click the Window’s Start button, and then select Control Panel.To install the TCP/IP protocol, follow these steps: If your PC is already set up with TCP/IP protocol, go to Step 2: “Install the SPS Software”.If you have a network card installed then you only need to verify that TCP/IP protocol has been configured.These installation steps are for setting up the TCP/IP protocol for first-time, stand-alone users. Step 1: Check and / or Install TCP/IP Protocolĭetermine if TCP/IP protocol is installed on the PC and install if necessary. If YES, go to Step 3: “Update the SPS Data”.

TIS 2000 SOFTWARE HOW TO

How to install TIS2000 of Tech II to have Service Programming System (SPS) ?īefore you install the SPS application, answer the following question to determine if the SPS application is already installed on the PC: “Is there a TIS 2000 icon on the Window’s desktop?” The computer has to come with Com port.Ħ) The Tech2 clone has to come with one RS232-DB9 adapter shown as below:Īnd make sure one end of RS232-DB9 adapter plug to the computer Com port and another end connect to the Tech2.

An Application CD which loads the SPS applicationĥ).

The GM Service Programming System (SPS) kit contains two compact discs (CD): If you get the free TIS2000 software without USB dongle, sorry, it will not work.ģ) If you need to program Saab ECU, you need specialized Saab TIS2000 CD and USB key.Ĥ) For SPS CD software, you need to buy TIS2000 CD plus USB Key.

So SPS will not able to program ECU for GM 2007 up.Ģ) SPS must work with TIS2000 with USB key. All programming steps are activated and finalized through the PCĬan China clone GM Tech2 scanner support SPS?ġ) TIS2000 does not support 2007+ models. The SPS application programs General Motors programmable control modules by using the Tech 2 Flash scan tool or the Next Generation scan tool as a “pass-thru” device to communicate program data to the vehicle control module. The GM Service Programming System (SPS) is a personal computer (PC) application used to reprogram vehicle electronic control modules (ECMs).

Tis 2000 software